Installing Options; Powerware Hot Sync Can Bridge Card - Eaton 9355 Installation Manual

Chapter 4
REPO (normally open)
Signal Input 2
Signal Input 1
Powerware Hot Sync

Installing Options

This section describes the Powerware Hot Sync
For other options, such as additional X-Slot
remote emergency power-off (REPO), relay output contacts, or programmable signal
inputs, refer to the Eaton 9355 UPS (20/30 kVA) Installation and Operation Manual.
Figure 12 shows the location of the communication options and control terminals on
the UPS.
REPO (normally closed)
DB-9 Communication Port
Figure 12. Communication Options and Control Terminals
CAN Bridge Card
®
The Powerware Hot Sync
provide connectivity for operational mode control and metering of a parallel system at
any UPS in the system.
Eaton 9355 Tie Cabinet (20/30 kVA) Installation Guide
X-Slot
Communication
Bay #1
Control
Terminals
Pull-Chain Output
Contacts (parallel only)
Relay Output Contacts
CAN Bridge Card, shown in Figure 13, can be installed to
®
Figure 13. Powerware Hot Sync
S
164201630 Rev D www.eaton.com/powerquality
CAN Bridge Card.
®
cards, power management software,
®
Plug-in Terminal Block
CAN Bridge Card
®
X-Slot
Communication
Bay #2
19