Advertisement
2SHUDWLQJWKHUHFHLYHU
This Installation and Operation Guide provides all the information you need to
setup and operate your PowerVu Headend Satellite Receiver.
)URQWSDQHOFRQWUROV GLVSOD\
The front panel of your Headend Satellite Receiver provides controls for switching
the receiver on and off, switching the receiver to Alt Mode operation, activating
and navigating menus, and for interfacing with the Smart Card. A Signal presence
LED and an Alternate Mode indicator LED are provided. A 4 digit, 7-segment LED
display provides visual identification of current receiver settings, and also pro-
vides user feedback when changing the current receiver setup via the front panel.
An introduction to each of the front panel buttons and indicators follows.
67$1'%<EXWWRQ
The STANDBY button switches the Headend Satellite Receiver on and off
(standby).
To switch the receiver on or off from the front panel…
STANDBY
When the receiver is switched on, the front panel LED display is ON. When
switched off (standby), all indicator and display LEDs are OFF, and a single dot
flashes ON and OFF, repeatedly.
0(18EXWWRQ
While viewing any channel you can use the MENU button (front panel) to display
the Main Menu.
To display the Main Menu…
MENU
INDICATOR L ED
STA NDB Y
MENU
O N/STA N DB Y
BU TTO N
Figure4. Front panel controls and display
6,*1$/LQGLFDWRU/('
The Signal indicator LED is ON when your Headend Satellite Receiver is synchro-
nized with the incoming digital video signal. If no incoming signal is detected or
recognized by the receiver, or if the receiver setup is incorrect, this LED is OFF. If
the incoming signal or signal synchronization is temporarily interrupted or lost,
this LED may turn OFF or may flicker (i.e., turn ON and OFF intermittently). Also,
if the receiver is not authorized to receiver programming via the local service pro-
vider, the SIGNAL LED flashes ON and OFF (i.e., ON and OFF). For more infor-
mation about troubleshooting your Headend Satellite Receiver, see "Appendix B
Troubleshooting".
STANDB Y
$/70RGHLQGLFDWRU/('
The ALT Mode indicator LED flashes ON and OFF when your Commercial Satel-
lite Receiver is operating in Alt-1 Mode, and is ON when operating in Alt-2 Mode.
When operating the receiver in Alt Mode, you can use the front panel keypad Alt
Mode functions to change the current receiver setup. When the receiver is in nor-
mal operating mode, this LED is OFF. For information about using Alt Mode func-
tions to operate your Headend Satellite Receiver, see "Setting up the receiver".
6HJPHQWGLVSOD\
Visual identification of current receiver settings is provided by a 4 digit, 7-segment
M EN U
LED display. The display provides you with immediate feedback when making
changes to the current receiver setup via the front panel buttons. When the receiver
is switched on, the 7-segment display shows the current channel.
ALT MOD E
SIGN AL PR ESENC E
NU M ERIC KEYPAD AND
INDICATOR L ED
M ULTI-FUN CTION B UTTON S
6,*1$/
C /K u
FE C
S .Q .
!
M O D E
S Y M
S IG
"
#
$
FR E Q
P O L
A FC
%
&
'
$/7
A LT
V IE W
ALPHA -N UM ER IC
M ENU B UTTON
DISPLAY W IN DO W
S EL E C T
Headend S atellite Receiver
Sm art C ard SLOT
Advertisement
