Meru Networks AP832 Installation Manual page 13

Figure 8: Assembled Mounting Bracket
Mounting Bar
4. Locate the 650-00232 15/16" T-Bar Adapter/Wall Mount and attach the AP to the mounting
bracket by pressing the bracket's Mounting Pins (shown in
sliding the bracket until it locks in place.
5. Gently press the underside of the AP against the mounting brace and rotate it into place until the
locking mechanism clicks.
6. Attach the legs for the mounting kit to the T-Bars in the ceiling by sliding the clips down onto each
respective bar.
7. Remove the top nut from each leg.
8. Lower the crossbar (with the AP attached) onto the legs and screw the nuts back on top of the bar.
9. Connect one end of the PoE Ethernet cable to the Ethernet connector on the AP.
Note:
Check that the AP832e is operating correctly before replacing the ceiling tile to the ceiling. Verify
correct operation using the LEDs, as shown in
© 2013 Meru Networks, Inc.
Mounting Brace
Clips attach to T-bar
Use a shielded Cat 5e (or greater) Ethernet cable in order to comply with
international electromagnetic emissions limits.
Check AP832e LED
Install the AP832e
Figure 4) to the AP's Receiving Slots and
Activity.
Installing AP832e xiii