Maintenance - WAGNER 0529017 Owner's Manual

Cleaning the Filters:
IMPORTAnT: Before every use, you should
inspect the air filter in the turbine to see if it
is excessively dirty. If it is dirty, follow these
steps to replace it.
IMPORTAnT: never operate your unit
without the air filter. Dirt could be sucked in
and interfere with the function of the unit.
1. Press the tabs on the side of the turbine to
remove the filter cover.
2. Remove the dirty filter from the turbine and
replace with a new one. The smooth side of the
air filter must be placed toward the turbine.
Secure the cover back onto the turbine.
Cleaning the Air Valve Tube:
note: If paint has entered the air tube, proceed as
follows.
1. Pull the air tube (a) at the top from the spray gun.
Screw off the valve cover (b). Remove the valve seal
(c). Clean all the parts carefully.
IMPORTAnT: The air tube and valve seal (c) are only
solvent-resistant to a limited extent. Do not immerse
in solvent, only wipe.
2. Place the valve seal (c) in the valve cover (b) with the
pin facing into the tube.
note: Installing the valve seal into the valve cover will
be much easier if the valve cover is inverted.
3. Turn the spray gun upside down and screw on the
valve cover (with valve seal inside) from underneath.
note: Turning the spray gun upside down will prevent
the valve seal from falling out of the valve cover during
reinstallation.
4. Place the air tube on the valve cover and on the nipple
at the spray gun.
3
© Wagner Spray Tech. - All Rights Reserved

Maintenance

1
(a)
(b)
(c)
2
(c)
(b)
4
English
15