Material Preparation - WAGNER 0529017 Owner's Manual

note: Material to be sprayed may need to be strained
to remove any impurities in the paint which may enter
and clog the system. Impurities in the paint will give
poor performance and a poor finish.
To Prepare the Material:
1. Stir the spraying material thoroughly.
2. Unscrew the cup from the spray gun.
3. After the material has been properly thinned and
strained, fill the container to desired level.
Thinning the material:
Before spraying, the material being used may need
to be thinned with the proper solvent as specified by
the material manufacturer. Never exceed the thinning
advice given by the coating manufacturer.
Do not thin with materials that have
a flashpoint below 70°F (21°C). The
material flashpoint should be shown on
the material container.
© Wagner Spray Tech. - All Rights Reserved

Material Preparation

1
2
3
English
5