Diagnostic Codes - Arctic Cat ZR 3000 Operator's Manual

With the altimeter mode selected by
pressing the Upper Right Button, press
and hold the Upper Right Button to set
the current altitude by using either Left
Button. When the proper altitude has
been set, press the Lower Right Button to
return to the main gauge display.
H. Engine Hour Meter/
Odometer/Trip Meter/
Clock
This display shows engine hours, odome-
ter, trip meter, or clock. Press the Lower
Right Button to change which parameter
is being displayed. The Engine Hour
Meter and Odometer cannot be reset. To
reset the trip meter, select the Trip Meter;
then press and hold the Lower Right But-
ton until the trip meter display reads 0.

NOTE: The clock can only be dis-
played in this position if it is not
already being displayed in the main
right screen. To set the clock when
the clock is in this position, press
and hold the Lower Right Button;
then use the procedure found in G.

Diagnostic Codes

Diagnostic codes are activated by the
ECM and may be displayed on the read-
out screen for a number of reasons.
If a code is displayed while the engine is
running, the ECM is receiving input that
is outside of its established parameters. If
a code has been activated, take the snow-
mobile to an authorized Arctic Cat Snow-
mobile dealer for service. If not under
warranty, this service is at the discretion
and expense of the snowmobile owner.
Refer to the following chart for a list of
possible diagnostic codes.
5000
Code
1 Failure in the fuel system.
2 Failure in injector (PTO).
3 Failure in injector (MAG).
4 Failure in barometric pressure sensor.
5 Open or short circuit in intake mani-
fold air temperature sensor.
6 Open or short circuit in water tem-
perature sensor.
7 Open or short circuit in throttle posi-
8 Open or short circuit in manifold air
pressure sensor.
9 Failure in crankshaft position sensor.
11 Failure in speed sensor.
12 Failure in coil (MAG).
13 Failure in coil (PTO).
14 Failure in ISC valve.
15 Failure in oxygen sensor.
19 Failure in camshaft position sensor.
25 Failure in shifting system/gear position
26 Malfunction in air pressure sensor.
29 Malfunction in shift control switch.
3000/7000
Code
P0016 Crankshaft Position -
Camshaft Position Correlation
P0030 O2 Heater Control Circuit
P0031 O2 Heater Control Circuit Low
P0032 O2 Heater Control Circuit High
P0107 Manifold Absolute Pressure
P0108 Manifold Absolute Pressure
P0112 Intake Air Temperature Sensor
P0113 Intake Air Temperature Sensor
P0114 Intake Air Temperature Sensor
Circuit Intermittent
P0115 Engine coolant temp sensor 1 circuit
P0117 Engine Coolant Temperature Sensor 1
P0118 Engine Coolant Temperature Sensor 1
P0119 Engine Coolant Temperature Sensor 1
Circuit Intermittent
P0120 Throttle position sensor circuit
P0121 Throttle Position Sensor Circuit
Range Performance
P0122 Throttle Position Sensor Circuit Low
P0123 Throttle Position Sensor Circuit High
Trouble
tion sensor.
switch.
Trouble
Circuit Low
Circuit High
Circuit Low
Circuit High
Circuit Low
Circuit High
11