Arctic Cat ZR 3000 Operator's Manual page 18

Jump-Starting

NOTE: Arctic Cat does not recom-
mend jump-starting a snowmobile
with a dead battery but rather to
remove the battery, service it, and
correctly charge it; however, in an
emergency, it may be necessary to
jump-start a snowmobile. If so, use
the following procedure to carefully
and safely complete this procedure.
! WARNING
Improper handling or connecting of a
battery may result in severe injury
including acid burns, electrical burns, or
blindness as a result of an explosion.
Always remove rings and watches.
1. On the snowmobile to be jump-started,
slide any terminal boots away.
! WARNING
Any time service is performed on a bat-
tery, the following must be observed:
keep sparks, open flame, cigarettes, or
any other flame away. Always wear
safety glasses. Protect skin and cloth-
ing when handling a battery. When ser-
vicing a battery in an enclosed space,
keep the area well-ventilated.
2. Inspect the battery for any signs of
electrolyte leaks, loose terminals, or
bulging sides. Leaking or bulging
battery cases may indicate a frozen
or shorted battery.
! WARNING
If any of these conditions exist, DO
NOT attempt to jump-start, boost, or
charge the battery. An explosion
could occur causing serious injury.
3. Inspect the vehicle to be used for
jump-starting to determine if voltage
and ground polarity are compatible.
The vehicle must have a 12-volt DC,
negative ground electrical system.
CAUTION
Always make sure the electrical sys-
tems are of the same voltage and
ground polarity prior to connecting
jumper cables. If not, severe electrical
damage may occur.
14
4. Move the vehicle to be used for the
jump-start close enough to ensure
the jumper cables easily reach; then
set and lock the brakes, shut off all
electrical accessories, and turn the
ignition switch OFF.

NOTE: Make sure all switches on
the snowmobile to be jump-started
are turned OFF.
5. Disconnect all external accessories
such as cell phones, GPS units, and
radios on both vehicles.
CAUTION
Failure to disconnect
accessories during
may cause system damage due to
power spikes.
6. Attach one clamp of the positive
(red) cable to the positive (+) termi-
nal (1) of the dead battery (C) being
careful not to touch any metal with
the other clamp; then attach the
other clamp of the positive (red)
cable to the positive (+) terminal (2)
of the good battery (B).

NOTE: Some jumper cables may be
the same color but the clamps or ends
will be color-coded red and black.
electronic
jump-starting
0744-527