Arctic Cat ZR 3000 Operator's Manual page 48

Adjusting Front (Ski)
Shock Springs
The front (ski) shock springs are individ-
ually adjustable for the terrain conditions
and driving style of the operator. The
spring adjuster nut has been set at the fac-
tory so the correct amount of threads are
exposed between the adjuster nut and the
threaded shock body as an initial setting.
Additional ski pressure can be obtained
by tightening the spring tension; ski pres-
sure can be decreased by relaxing spring
tension.

NOTE: Equal adjustments should
be maintained on both sides of the
snowmobile.
Front (ski) shock spring pre-load adjust-
ment is accomplished by loosening the
adjuster nut locking collar (B) from the
adjuster nut (A) and using the Spring
Adjuster Tool from the tool kit, rotating
the adjuster nut in whichever direction is
desired. Tighten the locking collar
against the adjuster nut.
On limited models, use the adjustment
lever located above the EVOL chamber
on the shock to adjust the damping.
There are three settings that may be cho-
sen 1, 2, or 3.
44
Adjusting Front Shock
Springs (Pantera 7000)
The front (ski) shock springs are individ-
ually adjustable for the terrain conditions
and driving style of the operator. The
spring adjuster nut has been set at the fac-
tory so the correct amount of threads are
exposed between the adjuster nut and the
threaded shock body as an initial setting.
Additional ski pressure can be obtained
by tightening the spring tension; ski pres-
sure can be decreased by relaxing spring
tension.

NOTE: Equal adjustments should
be maintained on both sides of the
snowmobile.
Front (ski) shock spring pre-load adjust-
ment is accomplished by loosening the
adjuster nut locking collar (B) from the
adjuster nut (A) and using the Spring
Adjuster Tool from the tool kit, rotating
the adjuster nut in whichever direction is
desired. Tighten the locking collar
against the adjuster nut.
0745-159
0748-941
0745-159
0745-159