Table of Contents
Advertisement
Symptom
"Aspect Marker", " Safety Zone Marker " or
"Area Marker" does not appear.
The fan starts to rotate even when "Fan"
under "Camera Link" is set to "On" or
"Fan Stop" is set to "On".
The fan does not stop even when "Fan"
under "Camera Link" is set to "On" or
"Fan Stop" is set to "On".
Loud fan noise
You forgot the password for "Protect
Settings".
The video display does not start up in the
condition that the power was turned off
last time.
The image quality for the User mode in
"Picture Mode" differs from the image
quality of presets.
In the "Multi View (Dual)" display, the
image quality of the screens on the left
and right differ.
98
Troubleshooting
• A channel with no signal, unsupported signal, or with "Input
Configuration" not set may be selected. Check the signal.
• The fan operates to lower the temperature inside the main unit. The fan
stops operating when the temperature inside has lowered.
• When "Fan" under "Camera Link" is set to "On", the down time may not
match the camera.
• The fan does not stop if the temperature inside the main unit is high.
Configure settings after the internal temperature has lowered.
• The fan may not stop in some conditions, for example when used at a
high temperature. Use the video display at the operating temperature
(
75) or lower.
• The fan operates at a faster speed than usual to lower the internal
temperature if "Fan Control" is set to "On" and when the temperature
inside the main unit has increased. The fan operates at normal speed
when "Fan Control" is set to "Off".
• When high-luminance content is displayed continuously, the temperature
inside the main unit rises even if the operating temperature is within
the recommended range, and the fan operates at a faster speed than
usual to lower the internal temperature. It is recommended to lower the
brightness of the video display.
• Press the jog dial and the button while the video display is in standby.
The configuration will be reset to the state where no password is set.
• Check the "Power on Setting" on the OSD menu. Set "Last memory"
to start up the video display in the condition that the power is turned off
last time.
• Select the preset mode by "Copy Picture Mode" and copy the settings.
• Check the settings of "Picture Mode", "Picture Function Target" under
"Channel Settings" or check the other settings for "Multi View (Dual)"
display.
Cause and Action
74
68
70
68
70
70
12
71
46
50
51
Advertisement
Table of Contents
