Adjusting Image Quality For Each Screen In Two Screen Display; Calibration Without A Pc - Canon DP-V2420 Instruction Manual

Adjusting image quality for each screen in two screen display (

In Multi View (Dual) display, image quality settings can be changed
on both displayed screens.
1. Press the MENU button to open the OSD menu.
2. Select "Channel Settings" → "Select Input Signal" using
the jog dial.
Select "Dual Input A,B" or "Dual Input C,D", and then press
the jog dial to confirm the setting.
3. Select "Channel Settings" → "Image Division" using the jog dial.
• Select "Multi View (Dual)", and then press the jog dial to confirm the setting. The screen changes to two screen
display.
• When selecting "Adjustment" menu, the currently selected screen is identified by L or R (Left or Right) being
displayed on the OSD menu screen.
• Select the screen for setting "Picture Mode". ("Channel Settings" → "Picture Mode" or "Picture Mode R"
Select "Picture Mode" in the screen on the left: Picture Mode
Select "Picture Mode" in the screen on the right: Picture Mode R
4. Adjusting the image quality.
5. When adjustments are completed, press the jog dial.
The screen returns to the original OSD menu.
Switching the target screen
• When the OSD menu is open:
-
In the "Adjustment" main menu, press the jog dial's button.
-
In the "Adjustment" main or sub menu, press the CH1 button.
• When the OSD menu is not being displayed: Move the jog dial ( ).
Note
• In the "Multi View (Dual)" display, the HDR (High Dynamic Range) and SDR (Standard Dynamic Range) displays can be
tested side by side. ("Adjustment"

Calibration without a PC (

When "User 1-7" under "Picture Mode" is selected, you can perform calibration using an external sensor, without using
the computer.
The supported external sensors are Konika Minolta Display Color Analyzers CA-310 and CA-210. Be sure to also read
the instruction manual of the CA-310 and CA-210.
1. Connect the display color analyzer to the USB port of the main unit.
2. Open the OSD menu and select "Adjustment" → "Detail Settings" → "Calibration".
Set each target value.
26 Operating the Video Display
"Detail Settings" "HDR/SDR View"
→ →
46)
46)
49)
50)