Canon DP-V2420 Instruction Manual page 59

Item
Area Marker "Area Marker" is used to check a specific area using a rectangular box.
Enable Switches the area marker On, Off.
On, Off
H Position Sets the start position (x-coordinate) to draw the rectangle (in increments of 2).
0 to 4086 (240)
V Position Sets the start position (y-coordinate) to draw the rectangle (in increments of 2).
0 to 2150 (120)
Width (dot) Sets the width of the rectangle (in increments of 2).
10 to 4096 (240)
Height (dot) Sets the height of the rectangle (in increments of 2).
10 to 2160 (120)
Mask Switches the mask color (in the marker).
Black, Half, Off
Line Turns On/Off the outlines of the rectangular box.
On, Off
Line Width Sets the width of the area marker line.
Thick, Normal, Thin
Line Color Sets the color of the area marker line.
White, Red, Green, Blue, Yellow, Cyan, Magenta
Line Sets the brightness of the area marker line.
Brightness High, Low
Setting Options (underline indicates factory default)
Note
"Area Marker" is not displayed in the following cases:
• When there is no signal, unsupported signal, or a channel with "Input Configuration" not set is
selected
• When an enlarged image is displayed
• During the execution of "Playback File" under "Screen Capture"
• When a "Test Pattern" is displayed
OSD Menu 59