Table of Contents
Advertisement
Item
Area Marker
Fan
Camera
Information
68
OSD Menu
Setting Options (underline indicates factory default)
When an ARRI cinema camera is connected to this device, the "H Position", "V Position", "Width",
and "Height" for the "Area Marker" change depending on the meta information.
ARRI Frame line 1A, ARRI Frame line 1B, Off
Note
• This cannot be set when "Marker Preset" is "Off".
Sets whether or not to stop the fan by linking with the camera's REC signal. When "Fan Control"
under "System Settings" is set to "On", the mode changes so that the fan can be stopped, and
when "Fan" is set to "On", the fan can be stopped by linking with the camera's REC signal. At room
temperature (25 °C), the fan remains off for approximately one minute. The fan operates at a faster
speed than usual before and after the fan is stopped to lower the internal temperature.
On, Off
Note
• This can be operated in "On" with REC signals supported by this function (Cinema EOS
cameras, Canon professional-use video cameras, ARRI cinema cameras).
• If the temperature inside the main unit increases while the fan is off, the message "Fan will be
rotated as the temperature is high." is displayed and the fan starts rotating approximately ten
seconds later. Since the temperature of the main unit has increased, the fan rotates faster than
usual.
• The video display's fan may start rotating earlier than the camera because the temperature
inside the main unit has increased.
• The fan may not stop in some conditions, for example when used at a high temperature.
Sets conditions to display camera information.
Automatic: Camera information is displayed for 4 seconds when the information has changed.
On: Camera information is always displayed.
Off: Camera information is not displayed.
Advertisement
Table of Contents
