Setting The Rca Output; Setting The Fm Tuning Step; Rds Setting - Pioneer SPH-DA100 Operation Manual

Customising preferences
2 Tap [Rear Speaker].
Tapping [ Rear Speaker
as follows:
• Full (default)
When no subwoofer is connected to the
rear output, select " Full ".
• Subwoofer
When a subwoofer is connected to the
rear output, select " Subwoofer ".
❐ Even if you change this setting, there will be
no output unless you turn the subwoofer
output on.
➲ For details, refer to Using the subwoofer
output on page 37.
❐ If you change this setting, subwoofer output
in the audio menu will return to the factory
settings.

Setting the RCA output

This product's preout (RCA rear output or sub-
woofer output) can be used for a full-range
speaker ( Full ) or subwoofer (
nection.
Initially, the product is set for a rear full-range
speaker connection ( Full
❐ " Preout " can be set only when the source is
set to " OFF ".
1 Display the "System" screen.
➲ For details, refer to Customising the system
settings on the previous page.
2 Tap [Preout].
Tapping [ Preout ] changes the settings as fol-
lows:
• Subwoofer (default)
When a subwoofer is connected to the
RCA rear output, select " Subwoofer ".
• Full
When no subwoofer is connected to the
RCA rear output, select " Full ".
❐ Even if you change this setting, there will be
no output unless you turn the subwoofer
output on.
➲ For details, refer to Using the subwoofer
output on page 37.
] changes the settings
Subwoofer ) con-
).
❐ If you change this setting, subwoofer out-
put in the audio menu will return to the fac-
tory settings.

Setting the FM tuning step

Normally the FM tuning step employed by
seek tuning is 50 kHz. When "
Frequencies) or " TA " (Traffic Announcements)
is on, the tuning step automatically changes to
100 kHz. But you can set the tuning step to
50 kHz when " AF " or "
Initially, this function is set to "
❐ " FM Step " can be set only when the source
is set to " OFF ".
1 Display the "System" screen.
➲ For details, refer to Customising the system
settings on the previous page.
2 Tap [FM Step].
Each time you tap [ FM Step
FM tuning step between "
" 100 kHz " while " AF " or "
❐ The tuning step remains at "
manual tuning.

RDS setting

Limiting stations to regional programming
When " Alternative FREQ
gional function limits the selection of stations
to those broadcasting regional programmes.
❐ This function is effective only when the
radio source is set to FM tuner.
1 Display the "System" screen.
➲ For details, refer to Customising the system
settings on the previous page.
AF " (Alternative
TA " is on.
100 kHz ".
] will switch the
50 kHz " and
TA " is on.
50 kHz " during
" is used, the re-
Engb
Chapter
08
39