Remote Access; Listen To Messages From Remote Access - VTech VC7151-102A User Manual

Remote Access

A two-digit security code is required to access the messages, or change the sensor
mode setting remotely, from any touch-tone telephone. The preset code is 19. You
can use this preset code, or set your own.
1. Dial your telephone number from any touch-tone telephone.
2. When the system plays your announcement, enter the two-digit security code.
3. Enter the one of the remote commands, # or *, to listen to message or change the
sensor mode.
Command
#
To listen to messages (see below).
* To change the sensor mode (see page 66).

Listen to Messages from Remote Access

1. Follow steps 1 and 2 in Remote access section on page 65 to enter remote
access mode.
Press # on your remote touch-tone telephone to enter the answering system
2.
operations command session.
3. You can enter one of the following remote commands to do the answering system
operations.
Command
1
Play all messages.
2
Play new messages.
3 Delete the current message (during playback).
33
Delete all old messages.
4
Repeat the current message (during playback).
5
Stop.
*5
Hear a list of remote commands.
6
Skip to the next message (during playback).
*7
Record a new announcement.
8
End the call.
0
Turn the answering system on or off.
Hang up or press 8 to end the call.
4.
Description
Description
65