Removing And Reinstalling The Monitor Stand - Lenovo ThinkCentre E93z Hardware Maintenance Manual

6. To reinstall the frame stand, insert the two tabs
chassis and lower down the frame stand as shown.
Figure 6. Installing the frame stand
7. Tighten the screw to secure the frame stand to the computer. Then, put the rubber back into the hole
to protect the screw.

Removing and reinstalling the monitor stand

Attention: Do not open your computer or attempt any repair before reading and understanding the Chapter
2 "Safety information" on page 3.
This section provides instructions on how to remove and reinstall the monitor stand.
Note: The monitor stand is available only in some models.
To remove and reinstall the monitor stand, do the following:
1. Remove all media from the drives and turn off all attached devices and the computer. Then, disconnect
all power cords from electrical outlets and disconnect all cables that are connected to the computer.
2. Disconnect all power cords from electrical outlets.
3. Disconnect the power cord, Input/Output cables, and any other cables that are connected to the
computer.
4. Place a soft, clean towel or cloth on the desk or flat surface. Hold the sides of your computer and gently
lay it down so that the screen is against the surface and the cover is facing up.
76
ThinkCentre E93z Hardware Maintenance Manual
1 on the frame stand into the corresponding holes in the