Printer Problems; Serial Port Problems - Lenovo ThinkCentre E93z Hardware Maintenance Manual

6. Click Defragment Now again to start a disk-defragmentation process.
On the Windows 8 or Windows 8.1 operating system, do the following:
1. Close any programs that are currently running and close any open windows.
2. On Windows 8, open File Explorer and click Computer. On Windows 8.1, open File Explorer.
3. Right-click your C drive entry and then click Properties.
4. Click the Tools tab and then click Optimize.
5. Click Optimize in the Optimize Drives window that is displayed to start a disk-defragmentation process.
Insufficient memory
Symptom: Insufficient memory
In general, the more memory that is installed, the better the Windows operating system runs.
Action: Install additional memory. For information about purchasing memory, see "Lenovo Support Web
site" on page 32. For step-by-step instructions on installing memory, see "Installing or replacing a memory
module" on page 107.
If these actions do not correct the problem, run the diagnostic programs (see "Lenovo Solution Center" on
page 53 for instructions). If you need technical assistance, see "Lenovo Support Web site" on page 32.

Printer problems

Symptom: The printer does not work.
Actions: Verify that:
1. The printer is turned on and is online.
2. Paper is loaded correctly.
3. The printer signal cable is securely connected to the correct parallel, serial, or USB connector on the
computer.
Note: Non-IEEE-approved printer signal cables might cause unpredictable problems.
1. Any device drivers and other software that came with the printer are correctly installed.
2. You have assigned the printer port correctly in your operating system, application program, or BIOS
settings. For more information about BIOS settings, see Chapter 6 "Using the Setup Utility program"
on page 55.
If the problem persists, run the tests described in the documentation that comes with your printer. If you
cannot correct the problem, have the computer serviced. See "Lenovo Support Web site" on page 32.

Serial port problems

Use this information to troubleshoot the serial port and devices attached to the serial port.
Symptom: Serial port cannot be accessed.
Actions:
• Ensure that the serial cable is securely connected to the serial port on the computer and to the serial
device. If the serial device has its own power cord, ensure that it is attached to a properly grounded
electrical outlet.
• If the serial device has its own On/Off switch, ensure that it is in the On position.
.
Chapter 5 Troubleshooting and diagnostics
51