Removing And Installing The Full-Function Monitor Stand - Lenovo ThinkCentre M73z Hardware Maintenance Manual

3. Remove the rubber cushion, and then loosen the screw
stand to remove it from the computer.
Figure 5. Removing the frame stand
4. To install the frame stand, position the frame stand over the computer so that the screw on the stand
aligns with the corresponding hole in the computer cover.
Figure 6. Installing the frame stand
5. Tighten the screw to secure the frame stand, and then install the rubber cushion.

Removing and installing the full-function monitor stand

To remove and install the full-function monitor stand, do the following:
1. Remove all media from the drives and turn off all attached devices and the computer. Then, disconnect
all power cords from electrical outlets and disconnect all cables that are connected to the computer.
2. Place a soft, clean towel or cloth on the desk or surface. Hold the sides of your computer and gently lay
it down so that the screen is against the surface and the cover is facing up.
74
ThinkCentre M73z Hardware Maintenance Manual
1 that secures the frame stand. Lift the frame