7. Remove the four screws on the hard disk drive bracket. Then slide the hard disk drive out of the hard
disk drive bracket.
Note: Do not touch the circuit board on the bottom of the hard disk drive.
Figure 15. Removing the hard disk drive from the hard disk drive bracket
8. Slide the new hard disk drive into the hard disk drive bracket until the hard disk drive is secured in place.
Ensure that the four screw holes in the hard disk drive are aligned with the corresponding holes in the
bracket. Install the four screws to secure the hard disk drive to the bracket.
Figure 16. Installing the hard disk drive into the hard disk drive bracket
9. Reconnect the cables to the hard disk drive.
.
Chapter 9
Replacing FRUs
83