Removing And Reinstalling The Transformer Stand - Lenovo ThinkCentre E93z Hardware Maintenance Manual

5. Remove the two rubber blocks
secure the monitor stand. Then, lift the monitor stand up to remove it from the computer.
Figure 7. Removing the monitor stand
6. To reinstall the monitor stand, insert the two tabs
the chassis and lower down the monitor stand as shown.
Figure 8. Installing the monitor stand
7. Tighten the two screws to secure the monitor stand to the computer. Then, put the rubber blocks
into the holes to protect the screws.

Removing and reinstalling the transformer stand

Attention: Do not open your computer or attempt any repair before reading and understanding the Chapter
2 "Safety information" on page 3.
This section provides instructions on how to remove and reinstall the transformer stand.
Note: The transformer stand is available only in some models.
1 that protect the screws
1 on the monitor stand into the corresponding holes in
2 . Carefully loosen the two screws
Chapter 9
2 that
77
.
Replacing FRUs