D This equipment is for professional use only. D Read all instruction manuals, tags, and labels before operating the equipment. D Use the equipment only for its intended purpose. If you are not sure, call your Graco distributor. D Do not alter or modify this equipment.
Page 3
WARNING WARNING FIRE, ELECTRIC SHOCK, AND EXPLOSION HAZARD Poor ventilation, open flames, or sparks can cause a hazardous condition and result in a fire or explosion and serious injury. D If there is any static sparking or you feel an electric shock while using this equipment, stop dis- pensing immediately.
Setup Charge Batteries Before First Use Modifying the Grease Gun for use with the Grease Gun Loader Valve. CAUTION WARNING Only charge the grease gun with the locking switch in Make certain that the open, threaded barrel end of the OFF position. Charging in the ON position will the grease gun barrel always points away from damage the charger and the motor.
Setup 4. Insert the assembled connecting rod into the 5. Screw the locking nut (2) and the plastic grip (1) barrel. The open section of the plunger is now onto the connecting rod. The hand lever grease visible inside the barrel. Ensure that the clamp gun is now ready for use.
(+5_C) or over 104_ F (+40_C). D Use only Graco approved chargers for EZ–Shot. Use of any batteries other than those specified could affect the safety of Important: Before using the EZ–Shot for the first time this unit.
Battery Replacement Important: If new batteries are used follow the “Charge 6. Slide new battery (5) fully into gun and replace Batteries Before First Use” procedure on page 4. battery cover (6). 1. Remove Cover (6). See Fig. 8. 7. Charge battery as needed. See Battery Charging procedure on page 6.
Graco’s written recommendations. This warranty does not cover, and Graco shall not be liable for general wear and tear, or any malfunction, damage or wear caused by faulty installation, misapplication, abrasion, corrosion, inadequate or improper maintenance, negligence, accident, tampering, or sub- stitution of non–Graco component parts.