Table of Contents
Advertisement
TR-2100 User Manual
Cable (small round black cable) that you just removed. Remove the four screws
that hold the GPS receiver and place the GPS receiver onto the new ACQ board
in the correct location. Make sure that the GPS Receiver's connector is pointing
towards the edge of the new ACQ board. Now put the four screws, washers, and
nuts in place to hold the GPS receiver in place on the new ACQ board. Make
sure not to over-tighten the nuts or you will damage the ACQ board.
7.
Place the new ACQ board into the same slot that the old ACQ was located.
Replace the Phillips screw on the left side of the ACQ board.
8.
Re-install all the cables that were removed in step 4, and close the front panel on
the unit.
9.
Set up a direct connection using DS32 software on your computer to the front
port of the TR-2100. When setting up communications, the program may prompt
you to update the Computer's / recorder's local configuration. If so, select
"Update the Remote's configuration".
10.
If possible, have the Master Station computer (running DS/DSA) call into the
TR-2100 by modem, to verify that the TR-2100's modem has been initialized
correctly.
11.
Make sure that the unit still has the correct parameters, and will trigger and
record a waveform on all channels that have voltage or current going into them.
58
Hide quick links:
Advertisement
Table of Contents
