Ametek TR-2100 Operation Manual page 59

TR-2100 User Manual
10. This screen is where the computer's RS-232 port properties are entered. Set
"Bits per second" to 57600. Set "Data bits" to eight (8). Set "Parity" to none
(N). Set "Stop bits to one (1). Set "Flow control" to Hardware. Select the
"OK" button when done and the following screen will appear.
11. Exit HyperTerminal. You will get a message saying, "You are still
connected. Are you sure you want to disconnect now?" Select the "Yes"
button. You will get the following message; "Do you want to save session
<Name you entered>?" For our example, the message is "Do you want to
save session TR-2100_Comm2_57600?" Select the "Yes" button.
12. Re-enter HyperTerminal by selecting (double clicking) the connection name
you just defined. For our example, the name is "TR-2100_Comm2_57600".
This should open a screen similar to the one shown below.
13. Establish communications to the TR by pressing the computer's ENTER key
three times. You will get a reply that will contain a complete configuration
of the system, followed by a CLI> prompt from the TR-2100 if a connection
is made (see the following screen). If you do not get a response, then your
baud rate is incorrect, the wrong cable is being used, you have an internal
53