Grizzly G0813 Owner's Manual page 29

30. Install fence tilt lever (see Figure 36).
Tilt Lever
Figure 36. Fence tilt lever installed.
The outfeed table MUST be level with
cutterhead knives when they are at top
dead center (at their highest point dur-
ing rotation). Otherwise, the workpiece
cannot properly feed past the cutterhead,
which may cause a kickback hazard for
the operator.
31. Place straightedge on outfeed table so it
extends over cutterhead, and use cutterhead
pulley to rotate cutterhead until one of the
knives is at top dead center (their highest
point during rotation), as illustrated in Figure
37.
Top Dead
Center
Straightedge
Outfeed
Figure 37. Using straightedge to check outfeed
table height.
Model G0813/G0814 (Mfd. Since 3/16)
32. Remove set screw from forked end of
33. Thread set screw through forked end of
Figure 38. Set screw threaded into end of
Infeed
When outfeed table height is correctly set,
knife (at top dead center) will barely touch
straightedge, as illustrated in Figure 37.
— If knife lifts straightedge off table or is
below straightedge, then outfeed table
height must be reset (refer to Setting
Outfeed Table Height, Steps 5-8, on
Page 48 for detailed instructions).
cutterhead guard shaft, wind torsion spring
⁄ -turn counterclockwise (viewed from
knob 1
2
top), then slide shaft down through mounting
hole on table.
Note: The guard may not fully seat in hole ini-
tially; however, rotating guard will allow shaft
to fully seat in hole.
cutterhead guard shaft, as shown in Figure 38.
When properly installed, guard is positioned
⁄ " above table for safety during operations.
3
8
Torsion
Spring
Knob
Forked End of
Shaft
cutterhead guard shaft.
-27-