GE LM10 Instruction Manual page 56

DEVICENET OPERATIONS
5–50
Data Formats for Device Inputs
Bit Position
Bit 4 Reserved
Bit 3 Reserved
Bit 2 Running 1
Bit 1 Warning
Bit 0 Fault
Assembly Object, Class Code 4, Instance 54. Use this object for data received by the master
from the slave device.
Attribute Access
3 Get Device inputs (see format/mapping below)
Data Formats for Device Inputs
Bit Position
Bit 7 Aux Sense 2 unput status
Bit 6 Aux Sense 1 unput status
Bit 5 Control from Devicenet
Bit 4 Reserved
Bit 3 Running 2
Bit 2 Running 1
Bit 1 Reserved
Bit 0 Fault
Assembly Object, Class Code 4, Instance 100. Use this object for data transmitted from the
master to the slave device.
Attribute Access
3 Set Control (see format below)
Data Formats for Device Inputs
Bit Position
Bit 7 Reserved
Bit 6 Reserved
Bit 5 Security to Min*
Bit 4 Reserved
Bit 3 Stop
Bit 2 Fault Reset
Bit 1 Run 2
Bit 0 Run 1
* If the LM10 has been put into Admin mode via the PDU display and this bit is set to '1', the
PDU display will continue to appear to be in Config mode but no settings will be able to be
changed. The LM10 will now be in 'User' mode.
Assembly Object, Class Code 4, Instance 101:
Attribute Access
3 Get Fault and status (see format below)
Name Value
---
---
---
---
---
Name/Description
Name Value
---
---
---
---
---
---
---
---
Name/Description
Name Value
---
---
---
---
---
---
---
---
Name/Description
LM10 MOTOR PROTECTION SYSTEM – INSTRUCTION MANUAL
CHAPTER 5: COMMUNICATIONS
Data Type Value
byte see below
Data Type Value
byte see below
Data Type Value
byte see below