Main Menu - GE LM10 Instruction Manual

CONFIGURATION SETTINGS
4.2.2

Main Menu

4–30
Table 4–1: LM10 Programmable Parameters
Parameter
DeviceNet fault
50 Hz system
Poll data
Reset run hours
Administration control
Auxiliary relay faults
independently selectable
Restore factory defaults
The main menu for the configuration settings is shown below. Press the CONFIG key to
access these settings.
GE LM10 1.70
Class: 10
MAC ID: 1
Baud: 500
Range/Options
Off, On
Off = 60Hz, On = 50Hz
1, 2, 3, 4
Resets on selection
Off, On
OvrCur, JAM, STALL, UnBalCur,
AuxSense, LoadLoss, PwrFail,
DevNet, Voltage
Resets on selection
Configuration
ENGLISH
CTs & CPTs
Starter Type
Configuration
CTs & CPTs
Starter Type
RUN 1 Setup
Configuration
Starter Type
RUN 1 Setup
RUN 2 Setup
Configuration
RUN 1 Setup
RUN 2 Setup
Time Delays
Configuration
RUN 2 Setup
Time Delays
Other Settings
Configuration
Time Delays
Other Settings
Aux Rly Faults
Configuration
Other Settings
Aux Rly Faults
Passcode, Login
Configuration
Aux Rly Faults
Passcode,login
Run Operations
LM10 MOTOR PROTECTION SYSTEM – INSTRUCTION MANUAL
CHAPTER 4: FUNCTIONALITY
Default Reference
Off page 4–34
Off page 4–34
1 page 4-34
N/A page 4–34
On page 4–34
All Off page 4–36
N/A page 4–38
See page –31.
See page –31.
See page –32.
See page –32.
See page –32.
See page –34.
See page –34.
See page –36.