Ordering; Order Codes - GE LM10 Instruction Manual

ORDERING

1.4 Ordering
1.4.1

Order Codes

1–6
The order codes for the LM10 Motor Protection System are shown below.
LM10 – D* – CT** – GF** –
Base unit LM10 |
Programmable X
display unit
1
Thermal overload
current transformer
Ground fault sensor
Cable
Reserved
Table 1–1: LM10 Order Codes
C* – **
| | |
| | |
| | |
XX | |
01 | |
02 | |
03 | |
04 | |
05 | |
XX |
01 |
02 |
03 |
04 |
05 |
06 |
X
1
XX
LM10 MOTOR PROTECTION SYSTEM – INSTRUCTION MANUAL
CHAPTER 1: INTRODUCTION
| LM10 Motor Protection System
| No display unit
| Programmable display unit (with
cable)
| No phase current transformer
| Current sensor, NEMA starter size
1, 3-phase, 27 A
| Current sensor, NEMA starter size
2 and 3, 3-phase, 90 A
| Current sensor, NEMA starter size
4, 3-phase, 200 A
| Current sensor, NEMA starter size
5, 1-phase, 300 A
| Current sensor, NEMA starter size
6, 1-phase, 600 A
| No ground fault sensor
| Ground fault sensor: 20 A, 0.44"
window
| Ground fault sensor: 20 A, 1.56"
window
| Ground fault sensor: 20 A, 2.08"
window
| Ground fault sensor: 20 A, 2.50"
window
| Ground fault sensor: 20 A, 3.31"
window
| Ground fault sensor: 20 A, 4.62"
window
| No cable
| 30-inch communication cable
from relay to PC
For future use