❸ Part Names Of The Projector; Front/Top - NEC PA803U User Manual

❸ Part Names of the Projector

Front/Top

The lens is sold separately. The description below is for when the NP13ZL lens is mounted.
Zoom Lever/Zoom Ring (→ page
Remote Sensor
(→ page 13)
Exhaust vent
Heated air is exhausted from here.
Lamp Cover (→ page 156)
(→ page 9)
Security Bar
Attach an anti-theft device.
The security bar accepts security
wires or chains up to 0.18 inch/4.6
mm in diameter.
Adjustable Tilt Foot
(→ page 29)
Mounting the strap
Before starting to use, mount the straps to the lamp cover and the filter cover for preventing them from dropping down.
Lamp cover
Preparation: Remove the lamp cover from the projector.
Refer to the clause "Replacing the lamp" on page 156
1. Insert the L-shaped part of the lamp cover strap (flat resinoid strap) to the protruded section on the rear
face of the lamp cover as the below illustration.
2. Insert the opposite side of the lamp cover strap to the hole on the projector body.
28)
Controls
about the lamp cover installation.
Hole for fixing the strap
6
1. Introduction
Indicator Section
(→ page 9)
Remote Sensor (located on the
front and the rear)
(→ page 13)
Adjustable Tilt Foot
(→ page 29)
Lens Cap
(The optional lens is shipped with
the lens cap.)
Lens
Focus Ring
(→ page 23)
Lens Release Button
(→ page 142)