Network; Energy-Saving - NEC PA803U User Manual

• Simultaneous display of 2 images (PIP/PICTURE BY PICTURE)
Two images can be projected simultaneously with a single projector.
There are two types of layouts for the two images: "picture-in-picture" in which a sub-picture is displayed on the
main picture, and "picture-by-picture" in which the main and sub pictures are displayed next to each other.
• Multi-screen projection using multiple projectors
This projetor equips the HDBaseT IN/Ethernet and HDBaseT OUT/Ethernet ports. Multiple projectors in same
brightness and resolution up to four units can be conneted in a daisy chain by a LAN*
without a video cable. A high quality picture is achieved by dividing and projecting high resolution videos among
the various projectors.
Furthermore, the boundaries of the screens are smoothed using an edge blending function.
* Use a commercially available CAT 5e STP cable or one in a higher specification.
1
• Seamless switch function for smoother screen changes when switching the signal
When the input connector is switched, the image displayed before switching is held so that that the new image can
be switched to without a break due to absence of a signal.
• Supports HDMI 3D format
This projector can be used to watch videos in 3D using commercially-available active shutter-type 3D eyewear and
3D emitters that support Xpand 3D.

Network

• Supports wired LAN
Equips the LAN and HDBaseT/Ethernet (RJ-45) ports. Utilizing a wired LAN connected with these ports, it enables
to control the projector by a computer.
• CRESTRON ROOMVIEW and Extron XTP compatibility
The projector supports CRESTRON ROOMVIEW and Extron XTP, allowing multiple devices connected in the
network to be managed and controlled from a computer Moreover, it enables to output and control image via an
Extron XTP transmitter connected with the projector..
• Convenient utility software (User Supportware) provided as standard
This projector supports our utility software (NaViSet Administrator 2, Virtual Remote Tool, etc.).
NaViSet Administrator 2 helps you control the projector by a computer via wired LAN connection.
Virtual Remote Tool helps you perform operations by a virtual remote control such as projector's power on or off
and signal selection via wired LAN connection. Moreover, it has function to send an image to the projector and
register it as the logo data.
Please visit our web site for downloading each software.
URL: http://www.nec-display.com/dl/en/index.html

Energy-saving

• Energy-saving design with a standby power consumption of 0.24W (100-130 V) / 0.30W (200-240 V)
When the on-screen menu's standby mode is set to "NORMAL" , the power consumption in the standby mode activat-
ing the Power Management is 0.24W (100-130 V) / 0.30W (200-240 V) and 0.20W (100-130 V) / 0.26W (200-240
V) when LAN is ineffective.
• "Eco mode" for low power consumption and "Carbon Meter" display
The projector is equipped with an "eco mode" for reducing power consumption during use. Furthermore, the
power-saving effect when the eco mode is set is converted into the amount of reductions of CO
this is indicated on the confirmation message displayed when the power is turned off and at "Information" on the
on-screen menu (CARBON METER).
3
1. Introduction
cable via these terminals
1
emissions and
2