❸ Part Names Of The Projector; Front/Top - NEC PH1202HL1 User Manual

❸ Part Names of the Projector

Front/Top

The lens is sold separately. The description below is for when the NP-9LS16ZM1 lens is mounted.
(→ page 8)
AC IN terminal
Connect the supplied power cord's
three-pin plug here, and plug the
other end into an active wall outlet.
(→ page 13)
Main power switch
While AC power is being supplied,
set the main power switch to ON
position (|), then your projector will
enter a standby state.
Intake vent
Takes in outside air to cool the unit.
There are air intake and ventilation
holes on the bottom.
(→ page ix, 57, 142)
Terminals
5
1. Introduction
Controls/Indicator panel
(→ page 7)
Remote Sensor (located on the
front and the rear)
(→ page 11)
Lens
Handle
Level Adjuster
(→ page 21)