NEC PA803U User Manual page 143

NETWORK SERVICE
HTTP SERVER
PJLink
AMX BEACON
CRESTRON
Extron XTP
TIP: The CRESTRON settings are required only for use with CRESTRON ROOMVIEW.
For more information, visit http://www.crestron.com
Set a password for your HTTP server.
This option allows you to set a password when you use the
PJLink feature.
NOTE:
• Do not forget your password. However, if you forget your password,
consult with your dealer.
• What is PJLink?
PJLink is a standardization of protocol used for controlling projectors
of different manufacturers. This standard protocol is established by
Japan Business Machine and Information System Industries Associa-
tion (JBMIA) in 2005.
The projector supports all the commands of PJLink Class 1.
• Setting of PJLink will not be affected even when [RESET] is done from
the menu.
Turn on or off for detection from AMX Device Discovery when
connecting to the network supported by AMX's NetLinx control
system.
TIP:
When using a device that supports AMX Device Discovery, all AMX NetLinx
control system will recognize the device and download the appropriate
Device Discovery Module from an AMX server.
Placing a checkmark will enable detecting the projector from AMX Device
Discovery�
Clearing a checkmark will disable detecting the projector from AMX
Device Discovery�
ROOMVIEW: Turn on or off when controlling the projector from
your PC.
CRESTRON CONTROL: Turn on or off when controlling the
projector from your controller.
• CONTROLLER IP ADDRESS: Enter your IP address of CREST-
RON SERVER.
• IP ID: Enter your IP ID of CRESTRON SERVER.
Set for connecting this projector to the Extron XTP transmitter. ON
will enable to connect with the XTP transmitter. OFF will disable
to connect with the XTP transmitter.
129
5. Using On-Screen Menu
Up to 10 alphanumeric
characters
Up to 32 alphanumeric
characters
—
Up to 12 numeric
characters
—