Connecting To Devices - Promax 27 User Manual

4.3

CONNECTING TO DEVICES.

The PROMAX-27 permits the connection to a PC or to a serial printer for data
transfer, by means of the connection cable model CC-PX27.
Do not connect any cable other than that supplied by the manufacturer,
otherwise serious damage may be caused to the equipment.
1) Prior to connecting the equipment to a PC, disconnect both from their
respective power supplies.
2) Connect the end of the connection cable corresponding to the PROMAX-27 to
connector [4] and the other end to the serial port of your computer or printer.
Once the computer or printer has been connected, select on the PROMAX-27 the
LOGGER operation mode. If PRINT function is selected data will be dumped to the
remote unit through the serial port.
The communication parameters used by the PROMAX-26+, and which therefore
must be defined on the remote unit (PC ) are the following:
Rate
Data bits
Parity
Stop bits
The remote control software RM-027 (optional accessory) permits to carry out
from a computer the following options:
1) CHANNELS PLAN PROCESSOR: Modify, add or delete channel plans.
2) DATALOGGER: Permits to edit and to save all the measurement contained in a
logger.
3) UPGRADE: Allows updating the PROMAX-27 software version.
Page 58
57600 bauds
8 bits
None
1
USER'S MANUAL. PROMAX-27
07/2008