Edit Channel Plan - Promax 27 User Manual

USER'S MANUAL. PROMAX-27
i) NOISE FREQUENCY
(Only for digital channels) Frequency at which is measured the level of noise
for digital channels.
j) STEP FREQUENCY
This option allows you to select the step frequency at the frequency tuning
modes and at the GENERATOR mode.
4.2.2.1

EDIT CHANNEL PLAN

To access the EDIT CHANNEL PLAN menu:
1.- Press key
2.- Press softkey [F5] (SETUP)
3.- Use the cursor keys [7] to scroll along the menu.
4.- Go to the parameter "EDIT CHANNEL PLAN" and press the selection key [8].
It appears the screen with the configuration parameters (figure 7).
The attached figure (Figure 7.-) shows an example of a channel plan. At the top of
the screen appears the name of the selected plan channel (CCIR in the attached
figure). Along the screen are listed the channels belonging to the channel plan. The
maximum number of channels that a plan channel could have is 140.
From left to right are the following columns:
NAME:
FREQUENCY:
OFFSET:
TYPE:
ACTIVE:
07/2008
[13].
It identifies the channel name.
It identifies the frequency associated to the channel (MHz).
It shows the displacement of the tuning frequency in MHz.
It indicates whether the channel is defined as analog (A) or
digital (D).
It indicates whether the channel is active (Y) or not (N).
EDIT CHANNEL PLAN: CCIR
NAME FREQUENCY OFFSET
C02 50.25 MHz +0.00 MHz
C03 55.25 MHz +0.00 MHz
C04 62.25 MHz +0.00 MHz
S01 105.25 MHz +0.00 MHz
S02 112.25 MHz +0.00 MHz
S03 119.25 MHz +0.00 MHz
S04 126.25 MHz +0.00 MHz
S05 133.25 MHz +0.00 MHz
S06 140.25 MHz +0.00 MHz
S07 147.25 MHz +0.00 MHz
S08 154.25 MHz +0.00 MHz
S09 161.25 MHz +0.00 MHz
BACK ALL DIG.
Figure 7.- Channel Plan Editor.
01:43:09
TYPE ACTIVE
D Y
D Y
D Y
D Y
D Y
D Y
D Y
D Y
D Y
D Y
D Y
D Y
EDIT BACK
Page 19