Zooming - Sony BRC-X1000 Operating Instructions Manual

If the camera moves in a different
direction from what you intended
The camera is preset to face toward the right whenever
the b button is pressed. You might wish to reverse the
direction in which the camera moves, for example, when
you change the direction of the camera while checking
the picture on the screen. In such cases, press the 2
(REV) button while holding down the L/R DIRECTION
SET button. To reset the setting, press the 1 (STD)
button while holding down the L/R DIRECTION SET
button.
Arrow button Movement of the
camera
Note
The above setting changes only the signal emitted from
the remote commander, and does not change the setting
of the camera itself. Therefore, repeat the setting process
for each remote commander if you are using more than
one remote commander.
If the POWER lamp and NETWORK lamp
of the camera flash simultaneously, and
PAN-TILT ERROR! is displayed on the
menu screen
When the camera is moved or turned by hand or by
external shock, the microcomputer inside the camera
may not be able to recall the pan/tilt position properly,
in which case the camera automatically stops.
To reset the pan/tilt position, press the PAN-TILT
RESET button or turn off the camera and turn it on
again.
Setting

Zooming

Press either of the ZOOM buttons.
L/R
DIRECTION SET
While holding down
STD
1
Press
farther away. (Wide
L/R
DIRECTION SET
slowly (SLOW side)
While holding down
REV
2
Press
When you perform pan/tilt operations while the camera
is in telephoto mode, the moving speed of the image on
the screen may be a little jerky.
43
SLOW ZOOM
T
Subject appears
W
angle) L/R
DIRECTION SET
Zooms in or out
Note
PAN-TILT
RESET
Subject appears
FAST
closer. (Telephoto)
T
W
Zooms in or out
quickly (FAST side)