System Menu - Sony BRC-X1000 Operating Instructions Manual

Time adjustment of 1 STEP for H PHASE:
Signal format of H PHASE
the camera
3840 × 2160/29.97p
Approximately
3840 × 2160/25p
0.067
1920 × 1080/59.94p
microsecond
1920 × 1080/50p
1920 × 1080/59.94i
Approximately
1920 × 1080/50i
0.135
1280 × 720/59.94p
microsecond
1280 × 720/50p
Note:

SYSTEM Menu

H PHASE
FINE
Approximately
0.0067
microsecond
Approximately
0.0135
microsecond
IMG FLIP (vertical flipping of the image)
When IMG FLIP is turned ON, the picture from the SDI
and HDMI outputs is flipped. The directions of pan and
tilt are also reversed.
If you change the IMG FLIP setting, turn off the camera
and turn it on again to activate the change.
Notes
• When you turn off the camera and turn it on again with
IMG FLIP turned ON, PAN REVERSE and TILT
REVERSE are turned ON. When you turn off the
camera and turn it on again with IMG FLIP turned
OFF, PAN REVERSE and TILT REVERSE are
turned off.
• If the IMG FLIP setting is changed, the coordinates
for pan and tilt are flipped and all preset values are
reset.
PAN REVERSE
When this is turned ON, the PAN direction is reversed.
TILT REVERSE
When this is turned ON, the TILT direction is reversed.
IR RECEIVE
If this is turned OFF, the camera does not receive signals
from the supplied remote commander.
Be sure to turn this ON when you use the supplied
remote commander.
Note
You cannot turn OFF, IR RECEIVE when using the
supplied remote commander. To turn off IR RECEIVE,
use the remote controller (not supplied) or VISCA
command.
40