Sony BRC-X1000 Operating Instructions Manual page 19

9-1
Connect the cables to the terminals at the back of
the camera.
Ceiling
Notes
• Make sure no load is applied to connectors of the
cables.
• For measures that prevent the cord of the AC
adapter (not supplied) from being pulled out,
refer to "Connecting the Camera" (page 23).
• For measures that prevent the HDMI cable from
being pulled out, proceed to "9-2" after
connecting the HDMI cable. Then, connect all
the other cables.
9-2
To help prevent the HDMI cable from being pulled
out, remove the HDMI cable locking screw
(M2.6 × 6, black), and use it to attach the supplied
HDMI cable fixing plate to the back of the camera.
Secure the HDMI cable with a commercially
available tie-wrap.
HDMI cable locking screw (M2.6 × 6, black)
HDMI cable fixing plate (supplied)
Note
Do not leave the HDMI cable attached to the camera
if you do not use it.
10
Flip the SONY nameplate and 4K or HD nameplate
around as necessary.
How to remove the camera
1
Remove the three screws which secured the camera
in Step 8 of "Installing the camera on the ceiling
(example)".
2
Turn the camera unit counter-clockwise to remove
it.
19
Tie-wrap (commercially
available)