Operating multiple cameras with
the remote commander
1
Set the IR SELECT switch on the rear of the camera
you want to operate to 1, 2 or 3.
1 2 3
2
Press the CAMERA SELECT button on the remote
commander that corresponds to the number set in
step 1.
1
AUTO
FAR
DATA SCREEN
You can then operate the specified camera(s).
Every time you operate the camera(s) using the remote
commander, the CAMERA SELECT button pressed in
step 2 lights up.
IR SELECT
POWER
CAMERA SELECT
CAMERA
2
3
SELECT
FOCUS
MANUAL
NEAR
BACK LIGHT
Adjusting the Camera
AUTO
FAR
Focusing on a subject
To focus the camera on a subject
automatically
Press the AUTO button.
The camera focuses on the subject in the center of the
screen automatically.
To focus the camera on a subject
manually
After pressing the MANUAL button, press either the
FAR or the NEAR button to adjust the focus.
Focusing on a far
off subject
Focusing on a
nearby subject
Shooting with back lighting
When you shoot a subject with a light source behind it,
the subject becomes dark. In such cases, press the
BACK LIGHT button.
To cancel the function, press the BACK LIGHT button
again.
Note
The BACK LIGHT button is enabled when MODE in
the EXPOSURE menu is FULL AUTO, SHUTTER Pri,
IRIS Pri, or GAIN Pri.
44
NEAR
MANUAL
BACK LIGHT
CAMERA SELECT
1
2
3
FOCUS
AUTO
MANUAL
FAR
NEAR
DATA SCREEN
BACK LIGHT
FOCUS
AUTO
MANUAL
FAR
NEAR
DATA SCREEN
BACK LIGHT
Subject appears
brighter.
STD
REV
1
2
3