Furuno FA-170 Installation Manual page 41

3.7.4 How to set the network protocol
Set the LAN network protocol according to the vessel's on-board network. [NAVNET]
protocol should be used where a NavNet series unit is the LAN network hub. Select
[450] for all other LAN networks.
1. Access the [SERVICE] menu referring to the procedure outlined at the start of this
section.
2. Select [OTHER SET], then press the ENT/ACK key.
3. Select [NW PROTOCOL], then press the ENT/ACK key.
Note: The rest of the [OTHER SET]
menu items are for technical personnel
only. Do not change these setting.
4. Select the appropriate protocol, then
press the ENT/ACK key. A confirma-
tion pop up is displayed.
5. Select [YES] to accept the new setting or [NO] to cancel and return to the options.
Selecting [YES] will restart the unit.
3.7.5 How to restore factory settings
This procedure resets the units to factory settings.
Be sure to set all appropriate settings from the [INITIAL SET] menu after completing
this procedure.
1. Access the [SERVICE] menu referring to the procedure outlined at the start of this
section.
2. Select [INTIALIZE], then press the ENT/ACK key.
3. Select [RESTORE FACTORY SET], then press the ENT/ACK key. The confirma-
tion pop up window shown below-right is displayed.
Note: The rest of the [INTIALIZE]
menu items are for technical personnel
only. Do not change these settings.
4. Select the [YES] or [NO] as appropri-
ate, then press the ENT/ACK key.
[YES]: Accept the new settings and restart the unit.
[NO]: Cancel and return to the options.
3. SETTINGS AND ADJUSTMENTS
OTHER SET
1 NW PROTOCOL
CHECKSUM
2
INITIALIZE
1 RESTORE FACTORY SET
2 PASSW
INITIALIZE SETTINGS OK?
3 ALL C
YES
450
450
NAVNET
NO
3-11