How To Set Up The I/O Ports - Furuno FA-170 Installation Manual

3.5

How to Set Up the I/O Ports

1. Access the [INITIAL SET] menu, following the procedure outlined in "How to ac-
cess the [INITIAL SET] menu" on page 3-1.
2. Select [I/O PORT], then press the ENT/ACK key.
Note: The figure above shows the default settings for all ports.
The available port settings are outlined in the table on the following page.
COM1
COM2 to COM3
COM4
COM5 to COM6
SENSOR1
SENSOR2 & SENSOR3
Note 1: When [MODE] is set to [BEACON] or [MONITOR], speed settings are fixed at
the default setting.
Note 2: For detailed information on data format and related speeds, see "DIGITAL
INTERFACE" on page AP-2.
Mode definitions
EXT DISPLAY
LONG RANGE
SENSOR
MONITOR
BEACON
SERVICE
DISABLE
I / O PORT
PORT MODE
COM1 EXT DISPLAY
COM2 EXT DISPLAY
COM3 EXT DISPLAY
COM4 EXT DISPLAY
COM5 EXT DISPLAY
COM6 EXT DISPLAY
SENSOR1 SENSOR
SENSOR2 SENSOR
SENSOR3 SENSOR
: CURSOR : SELECT
ENT
PORT
EXT DISPLAY
LONG RANGE
BEACON
MONITOR
SERVICE
DISABLE
Same as COM1.
EXT DISPLAY
LONG RANGE
SENSOR
BEACON
MONITOR
SERVICE
DISABLE
Same as COM4.
SENSOR
DISABLE
Same as SENSOR1.
MODE
External display (Radar, ECDIS, Pilot plug, etc.).
Long range communication device (Inmarsat C, etc.).
GPS, Gyrocompass, ROT, etc.
For FA-1702 Monitor Unit.
For Beacon Receiver.
For service personnel only. Do not use.
Disable the port.
3. SETTINGS AND ADJUSTMENTS
SPEED
38400baud
38400baud
38400baud
38400baud
38400baud
38400baud
4800baud
4800baud
4800baud
: BACK
ENT
MODE SPEED (baud)
4800, 38400
4800, 38400
4800
57600
4800, 38400
-
Same as COM1.
4800, 38400
4800, 38400
4800, 38400
4800
57600
4800, 38400
-
Same as COM4.
Fixed at 4800
-
Same as SENSOR1.
Definition
3-7