Furuno FA-170 Installation Manual page 16

1. MOUNTING
4. Referring to the figure below, unlock two adjoining sides of the front panel, then
remove the front panel. To unlock the front panel, lift the locking tabs gently, then
pull the locking tabs away from the unit.
Locking tabs - closeup
5. Referring to the figure below, fit the optional F Mount Cushion Kit (OP05-141) to
the rear of the FA-1702. Take care to align the screw holes in the cushion to the
screw holes on the FA-1702.
Where the optional F Mount Cushion Kit is not used, proceed to step 6.
6. Run the cabling through the cutout, then, referring to section 2.3.1, connect the
necessary cabling to the FA-1702.
Console Console
7. Referring to the figure above, fit the FA-1702 to the cutout, then use the supplied
screws to secure the FA-1702 to the flush mount panel. Note that the screw loca-
tion for fixing the FA-1702 to the cutout with no flushmount panel is the same as
indicated in the figure above.
1-10
Rear view of FA-1702
Fit the F Mount Cushion Kit (option) to
the location shown above.
Cabling Cabling
Console Console
Screw locations Screw locations
Secure the FA-1702 to Secure the FA-1702 to
the flushmount panel. the flushmount panel.