Parameters - Siemens Simatic ET 200SP Manual

4.2

Parameters

Parameters of the AQ 2×U/I HS
The effective range of the parameters depends on the type of configuration. The following
configurations are possible:
● Central operation on an ET 200SP oder an einem ET 200SP Open Controller CPU
● Distributed operation on PROFINET IO in an ET 200SP system
● Distributed operation on PROFIBUS DP in an ET 200SP system
In addition to assigning parameters with the configuration software, you can also set the
parameters in RUN mode (dynamically) using the user program. When assigning parameters
in the user program, use the "WRREC" instruction to transfer the parameters to the module
by means of data records; see section Parameter assignment and structure of parameter
data record (Page 38).
The following parameter settings are possible:
Table 4- 2 Configurable parameters and their defaults (GSD file)
Parameter
Sampling rate
Diagnostics:
No supply voltage L+
Diagnostics:
Short-circuit to ground
1
Diagnostics:
Overflow
Diagnostics:
Underflow
Diagnostics:
Wire break
2
Output type/range
Analog output module AQ 2xU/I HS (6ES7135-6HB00-0DA1)
Manual, 09/2016, A5E03576140-AD
Value range
1 value/cycle
Disable
•
Enable
•
Disable
•
Enable
•
Disable
•
Enable
•
Disable
•
Enable
•
Disable
•
Enable
•
Deactivated
•
Voltage +/- 10 V
•
Voltage +/- 5 V
•
Voltage 0 to 10 V
•
Voltage 1 to 5 V
•
Current +/- 20 mA
•
Current 0 to 20 mA
•
Current 4 to 20 mA
•
Default Reconfigura-
tion in RUN
1 value/cycle No
Disable Yes
Disable Yes
Disable Yes
Disable Yes
Disable Yes
Current 4 to Yes
20 mA
Parameters/address space
4.2 Parameters
Effective range with configura-
tion software, e.g. STEP 7
(TIA Portal)
GSD file GSD file
PROFINET IO PROFIBUS DP
Module Module
Channel Channel
Channel Channel
Channel Channel
Channel
Channel Channel
Channel Channel
3
19