Siemens Simatic ET 200SP Manual page 33

Errors/accuracies
Output ripple (in relation to output range, band-
width 0 kHz to 50 kHz), (+/-)
Linearity error (in relation to output range), (+/-)
Temperature error (in relation to output range),
(+/-)
Crosstalk between outputs, max.
Repeat accuracy in settled state at 25 °C (in rela-
tion to output range), (+/-)
Operational limit in the entire temperature range
Voltage in relation to output range, (+/-)
Current in relation to output range, (+/-)
Basic error limit (operational limit at 25 °C)
Voltage in relation to output range, (+/-)
Current in relation to output range, (+/-)
Isochronous mode
Isochronous mode (application synchronized up to
terminal)
Execution and activation time (TCO), min.
Bus cycle time (TDP), min.
Interrupts/diagnostics/status information
Substitute values can be applied
Interrupts
Diagnostics interrupt
Diagnostics alarms
Diagnostics
Monitoring of supply voltage
Wire break
Short-circuit
Overflow/underflow
Diagnostics display LED
Monitoring of supply voltage (PWR LED)
Channel status display
For channel diagnostics
For module diagnostics
Electrical isolation
Electrical isolation of channels
Between the channels
Between the channels and the backplane bus
Between the channels and the supply voltage of
the electronics
Insulation
Insulation tested with
Analog output module AQ 2xU/I HS (6ES7135-6HB00-0DA1)
Manual, 09/2016, A5E03576140-AD
Technical specifications
6.1 Technical specifications
6ES7135-6HB00-0DA1
0.02%
0.03%
0.003%/K
-50 dB
0.03%
0.2%
0.2%
0.1%
0.1%
Yes
70 µs
125 µs
Yes
Yes
Yes
Yes
Yes; channel-based, only for output type current
Yes; channel-based, only for output type voltage
Yes
Yes; green PWR LED
Yes; green LED
Yes; red LED
Yes; green/red DIAG LED
No
Yes
Yes
707 V DC (type test)
33