Siemens Simatic ET 200SP Manual page 20

Parameters/address space
4.2 Parameters
Parameter
Reaction to CPU STOP •
Substitute value
Potential group
No diagnostics detection between -0.5 V and +0.5 V (no short-circuit detection)
1
No diagnostics detection between -3 mA and +3 mA (no wire break detection)
2
Due to the limited number of parameters of a maximum of 244 bytes per ET 200SP station with a PROFIBUS GSD
3
configuration, the parameter assignment options are restricted. If required, you can still assign these parameters using
the data record 128 as described in the column "GSD file PROFINET IO" (see table above). The parameter length of the
I/O module is 7 bytes.
Note
Unused channels
A deactivated channel always returns the value "no current or voltage".
20
Value range
Shut down
Keep last value
•
Output substitute value
•
For permissible substitute
values for the various output
ranges, see Parameter as-
signment and structure of the
parameter data record
(Page 38) appendix, Substi-
tute values → Codes for sub-
stitute values table
Use potential group of the
•
left module (dark-colored
BaseUnit)
Enable new potential
•
group (light-colored Ba-
seUnit)
Default Reconfigura-
tion in RUN
Shut down Yes
0 Yes
Use potential No
group of the
left module
Analog output module AQ 2xU/I HS (6ES7135-6HB00-0DA1)
Effective range with configura-
tion software, e.g. STEP 7
(TIA Portal)
GSD file GSD file
PROFINET IO PROFIBUS DP
Channel Module
3
Channel Channel
Module Module
Manual, 09/2016, A5E03576140-AD