5. Setting the Exposure Conditions
Set the plate ejection method for output, and select mirror output, positive/negative
output, and exposure conditions for the layout method.
1. Select [Set exposure mode] in the offline screen and press [OK]. The
ejection method selection screen appears. (If an online processor is not
connected, the exposure condition setting screen (Fig. 5-37) will appear instead
of the ejection method selection screen.)
Processor/
Fig. 5-36 Ejection method selection screen
2. Select the ejection method and press [OK]. The exposure condition setting
screen appears.
Fig. 5-37 Exposure condition setting screen
Mirror:
• Do not perform mirror output. When exposure takes place in mirror output
!
CAUTION
mode, spiral correction is reversed, producing a skewed image.
• Do not set negative output (exposure condition) for a positive plate. If a
negative output setting (exposure condition) is used for output on a
positive plate, exposure remnants may occur on the burn out edges. If
negative output is necessary, use the RIP invert function.
Manual
ESC
OK
: Eject an exposed plate from the rear outlet of the PT-R (if an online
processor is connected, the plate will pass through the online
processor).
: Eject an exposed plate to the PT-R's ejection table.
Mirror
Posi/Nega
Layout
1
ESC
SAVE
: Not mirror output
: Mirror output
1 2 3
Posi/Nega:
: Positive output
: Negative output
Chapter 5 User Menu
5-29