DAINIPPON SCREEN PLATE RITE 4300 User Manual page 13

Before attaching the plate to the PT-R, verify that no paper or
pieces of packaging remain on either side of the plate. The thermal
laser may cause paper or packaging to ignite and start a fire in the
PT-R.
The edges of the plate are very sharp. When handling the plate, be
sure to use anti-slip protective gloves. If handled with bare hands,
the edges of the plate may cause injury.
Store plates in a place where the height is appropriate for removal
without hurting your back. Repeated strain to the back can lead to
lower back pain.
Do not put your weight on the punch debris receptacle on the back
of the PT-R. Doing so could lead to damage to the tray or an
accident resulting from tripping.
Do not cover the PT-R with a cloth or block its air vents in any way.
!
CAUTION
Regarding the safety of the PT-R
NOTE
• Electrical safety
The PT-R has been designed, tested, and evaluated in accordance with IEC950 of
the "Safety of Information Technology Equipment, Including Electrical Business
Equipment" electrical safety standards.
• Laser safety
The PT-R has been designed, tested, and evaluated in accordance with the
following laser safety standards:
• "U.S. Federal Regulations 21 CFR 1040.10," which accompany the rules of
the "Center of Device and Radiological Health (CDRH)" of the U.S. Food and
Drug Administration.
• "Safety of Laser Products" of IEC 60825.
"Equipment Classification"
"Requirement"
"User's Guide"
CAUTION
Chapter 1 Ensuring Safety
1-3