Overview Of Information Settings - DAINIPPON SCREEN PLATE RITE 4300 User Manual

PT-R4300 USERS MANUAL

5. Overview of Information Settings

The information settings in the PT-R have the following configuration. This
information must be set before a plate can be loaded in the PT-R and exposed.
Printing machine information
Comments
Plate information number
Grip direction
Leading and trailing grip margins
Centering
Offset when centering is OFF
Punch number
Fine adjustment of image position
Exposure conditions
Mirror
Negative/positive
Layout
Offset for multi-output
Media type information:
This sets information regarding the plate manufacturer, model number, and
thickness. 15 types can be registered. In addition to the 15 types (No. 1 through
15. that can be registered, there are also 15 types (No. 31 through 45) that have
been pre-registered, and these can be copied to No. 1 through 15.
Plate information:
This sets the plate size and media type information number. 15 types can be
registered.
Printing machine information:
This sets the plate information number, grip, centering, and punch information.
15 types can be registered.
Punch information:
This registers punch comments. 9 types can be registered. (Note that there is a
limit to the number of punch units that can be attached.) A service technician
sets the punch block number and punch interval when he installs an optional
punch mechanism.
Exposure conditions:
Only one type can be registered. These settings are effective regardless of the
printing machine information selected.
• Set the information in the following order: media type information, plate
NOTE
information, printing machine information, and then exposure conditions. For
more details, refer to Chapter 5 "User Menu."
• When you instruct the host computer to output to the PT-R, the plate data set in
the printing machine information that was selected when the plate was loaded is
automatically selected, and output takes place according to the conditions set in
the printing machine information.
4-8
Plate information
Comments
Media type information number
Size
Punch information
Comments
(Punch block number)
(Punch interval)
Fig. 4-11 Configuration of information settings
Media type information
Comments
Positive type / negative type
Thickness
Detection distance for the plate
poor contact sensor
Discharge direction
(when connected to the AT-M)
Laser power for each resolution
Rotational speed for each resolution
Focus for each resolution
Zoom for each resolution
Primary scan length correction for each resolution