Errors That Do Not Need To Be Reset; Errors That Need To Be Reset - DAINIPPON SCREEN PLATE RITE 4300 User Manual

3.1 Errors that Do Not Need to be Reset

If there is no need to perform anything to reset the error, pressing [OK] at the error
display screen will bring back the original screen (or its previous menu screen) so
you can resume operation.

3.2 Errors that Need to be Reset

If the error requires you to reset the error before you can resume operations, pressing
[OK] at the error display screen will bring up one of the screens shown on the
following page. Pressing [ESC] on these screens will return you to the error display
screen and pressing [Detail] brings up the detailed error message.
Press [START] button
Pressing [START] button begins initialization
?
Exxxx : Press [START] button.
Pressing [START] button
begins initialization.
ESC
Fig. 7-20 Error reset request screen (1)
Press [START] to begin initialization (error reset). After initialization is
properly completed, you will return to the original screen (or the previous menu
screen).
Remove plate in transport unit and close door. Initialization begins
when door is closed.
This message appears if it is necessary to remove a plate from the transport unit
before starting initialization (error reset).
?
when door is closed.
ESC
Fig. 7-21 Error reset request screen (2)
Remove the plate from the transport unit (insertion table, ejection table, or both)
and then close the operation door. When the operation door is closed,
initialization will begin. After initialization is properly completed, you will
return to the original screen (or the previous menu screen).
START
Exxxx : Remove plate in transport unit
and close door. Initialization begins
Detail
Detail
Chapter 7 Messages
7-11