Contec AD12-64(PCI) User Manual page 23

Setup
Method of installing two or more Boards
(For use under Windows 95 version 4.00.950B or 4.00.950C)
Follow the procedure below to install two boards for use under
Windows 95 version 4.00.950B or 4.00.950C.
(1) Check the board ID of the first board. Then plug it into a PCI
(2) Check that the first board has been set up correctly, as
(3) Exit Windows 95 and turn the personal computer OFF.
(4) Check the board ID of the second board. Then plug it into a
(5) Turn the personal computer ON again to start up Windows 95.
(6) The OS will then automatically install the second board.
For installing the third board and any additional boards, follow the
same steps as those for installing a second board. Before you can
install a third board or additional boards, all boards that are already
installed must be in PCI bus slots.
Notes!
- A second board cannot be properly installed unless the resources
(I/O addresses and interrupt level) to be used for the board can
be allocated. Before attempting to install a second board, first
determine which PC resources are free.
- The resources used for each board do not depend on the location
of the PCI bus slot or the board itself. If you remove two or
more boards that have already been installed and then re-mount
one of them on the computer, it is unknown which one of the sets
of resources previously assigned to the two boards is assigned to
the re-mounted board. In this case, check the resource settings
again.
16
bus slot. Finally, start up Windows 95 to install the first
board correctly.
described in "Checking resources." Be sure to complete
installation of the first board before attempting to install the
second one.
PCI bus slot. Assign to the second board a board ID different
from that assigned to the first board.
When the installation has been completed, re-check the
assigned resources.
AD12-64(PCI), AD12-16(PCI)