Contec AD12-64(PCI) User Manual page 21

Setup
Method of installing two or more Boards
(For use under Windows 95 version 4.00.950 or 4.00.950a)
Follow the procedure below to install two boards for use under
Windows 95 version 4.00.950 or 4.00.950a.
(1) Check the board ID of the first board, plug it into a PCI bus
(2) Check that the first board has been set up correctly, as
(3) Exit Windows 95 and turn the personal computer off.
(4) Check the board ID of the second board, then plug it into a PCI
(5) Turn the personal computer on again to start up Windows 95.
(6) Windows 95 will come up with the [New Hardware] detection
(7) The [Select Hardware Type] dialog box will then appear. In
(8) In the [Select Device] dialog box that appears, select
(9) The [Change System Settings] dialog box appears. Follow
(10) When Windows 95 is restarted, installation of the second board
14
slot, then start up Windows 95 to install the first board
correctly.
described in "Checking resources." Be sure to complete
installation of the first board before attempting to install the
second one.
bus slot. Assign ID to the second board a board ID that is
different from the ID assigned to the first board.
dialog box. In [Multimedia Device: Select which driver you
want to install for your new hardware.], select [Select from
List].
[Select Hardware Type to Install], select [Other Devices].
[CONTEC] from [Manufacturers] and select [CONTEC Co.,
Ltd. - AD12-x(PCI)] from [Models].
the messages to restart the computer.
is completed. Check the assigned resources again.
AD12-64(PCI), AD12-16(PCI)