Configuring Bgp4+ Route Advertisement; Configuring Bgp4+ Aggregation Advertisement - Zte ZXR10 T600 User Manual

St- Command
ep
1 router bgp <as-number>
ZXR10(config)#
2
ZXR10(config-router)#
t-mask>
3
ZXR10(config-router)#
<metric-value>][route-map <map-tag>]
R1 configuration:
ZXR10_R1(config)#router bgp 100
ZXR10_R1(config-router)#neighbor 2005::2 remote-as 200
ZXR10_R1(config-router)#address-family ipv6
ZXR10_R1(config-router-af)#neighbor 2005::2 activate
ZXR10_R1(config-router-af)#network 2001::/64
R2 configuration:
ZXR10_R2(config)#router bgp 200
ZXR10_R2(config-router)#neighbor 2005::1 remote-as 100
ZXR10_R2(config-router)#address-family ipv6
ZXR10_R2(config-router-af)#neighbor 2005::1 activate
ZXR10_R2(config-router-af)#network 2003::/64
In the above configuration, R1 and R2 mutually define the peer
party as BGP neighbor. An EBGP session will be established be-
cause R1 and R2 belong to different ASs. R1 will advertise the
network 2001::/64 and R2 will advertise the network 2003::/64.
Configuring BGP4+ Route
Advertisement
To configure BGP4+ route advertisement, perform the following
steps.
network <ipv6-address><ne
redistribute <protocol>[metric
Result: BGP4+ route advertisement has been configured.
Configuring BGP4+ Aggregation
Advertisement
BGP4+ can aggregate the learnt multiple routes into one routing
information for advertising outside, thus greatly reducing the num-
ber of entries in routing table.
Confidential and Proprietary Information of ZTE CORPORATION
Chapter 8 BGP4+ Configuration
Function
This enters BGP4+
configuration mode.
This advertises the known
network, which can be learned
through connected routes,
dynamic routing and static
routes.
This command redistributes
the routes learnt by other
routing protocols to BGP
routing table.
55