Ospfv3 Basic Configuration; Enabling Ospfv3 - Zte ZXR10 T600 User Manual

ZXR10 T600/T1200 User Manual (IPv6 Volume)
St- Command
ep
1
ZXR10(config)#
2
ZXR10(config-router)#
36 Confidential and Proprietary Information of ZTE CORPORATION
Its LS type is 0x2001. It can generate one or multiple LSAs on
each router within an area.
� Network LSA
Its LS type is 0x2002. It can generate network LSAs for each
broadcast and NBMA link within an area, which supports two
or multiple routers. Network LSAs are created by DR on this
link.
� Inter-area prefix LSA
Its LS type is 0x2003. It is equivalent to the Type-3 LSA in
OSPFv2. Created by area border router, the inter-area prefix
router LSA describes IPv6 address prefixes in other areas. For
stub areas, inter-area prefix LSA can also be used to describe
default route.
� Inter-area router LSA
Its LS type is 0x2004. It is equivalent to the Type-4 LSA in the
IPv4. Created by ABR, it describes ASBR to other areas.
� AS external LSA
Its LS type is 0x4005. It is created by the ASBR and describes
ASBR to other area.
� Link LSA
Its LS type is 0x0008. A router advertises separate link LSA to
each link connecting with it. These LSAs have local link flooding
range and will not be flooded out of the related link.
� Intra-area prefix LSA
Its LS type is 0x2009. A router uses the intra-area prefix LSA
to advertise one or multiple IPv6 address prefixes, which are
associated with the router itself, the connected stub network
segment and the connected transit network segment.

OSPFv3 Basic Configuration

Enabling OSPFv3

To enable OSPFv3, perform the following steps.
ipv6 router ospf <process-id>
router-id <router-id>
Function
This enables an OSPFv3
process.
This specifies the Router ID
for an OSPFv3 process.